More information about the Inkle Loom:

The Inkle warp lengths can be: from 1.3m (51″) to 2.8m (110″)
The Inkle warp widths can be: up to 75mm (3″)

• Made from Silver Beech hardwood.  You will assemble the loom and glue all the pegs into place.
• The warp tension can be adjusted with the adjustable tension peg.
• Belt shuttle, clamp and a nice instruction manual from Ashford are included.

Warp Yarns to use:

Use strong, smooth and colorful yarns.  Your weaving will be warp faced so the warp colors will determine how your finished piece looks.

• Mercerized cotton (like our 3/2 Tubular Spectrum Yarns) is an ideal warp yarn.  It is smooth and strong and slides well.
• Most wool is suitable but avoid wool that is soft or hairy (these tend to cling to each other and make it difficult to obtain a clean, open shed).
• Textured and metallic threads, silk and nylon add variety to your warp.
• Be experimental but make sure all threads have about the same amount of elasticity, otherwise the surface will be uneven.

Weft yarns to use:

As inkle weaving produces a warp faced cloth, the edges of the weft will show as a loop on the side of your weaving.  Therefore, the weft should either contrast for a nice pop of color, or blend well with the outer warp color.

•   8/16 unmercerized cotton, a thick soft yarn
• Use the warp threads in any combination (1-4 strands) to achieve the desired thickness of your woven fabric.

Width of the Warp:

Because the weft thread is pulled tight, the weaving will be reduced to about half the original width of the warp. However, if you want to increase or decrease the width at any stage, this is done by the amount of tension on the weft thread.

The Shed:

• The shed is obtained by the use of leashes. A thread NOT going through a leash is called an “open” thread.
• Shed 1 – is made by pushing down on all the open threads
• Shed 2 – is made by lifting all the open threads

Inkle Loom includes Belt Shuttle, clamp and instruction manual.